Add files via upload

Marlin/Configuration.h

@@ -1,5 +1,5 @@
 /**
- * Marlin 3D Printer Firmware
+ * 5000arlin 3D Printer Firmware
  * Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
  *
  * Based on Sprinter and grbl.
@@ -950,8 +950,9 @@
     #define MAX_JERK_EDIT_VALUES {20, 20, 0.6, 10 } // ...or, set your own edit limits
   #endif
 #endif
+
 #if ENABLED(HIGH_SPEED_1)
-#define DEFAULT_EJERK 10.0  // May be used by Linear Advance
+#define DEFAULT_EJERK 5.0  // May be used by Linear Advance
 #else
 #define DEFAULT_EJERK 5.0  // May be used by Linear Advance
 #endif
@@ -976,7 +977,7 @@
  *
  * See https://github.com/synthetos/TinyG/wiki/Jerk-Controlled-Motion-Explained
  */
-#define S_CURVE_ACCELERATION
+//#define S_CURVE_ACCELERATION
 
 //===========================================================================
 //============================= Z Probe Options =============================
@@ -1153,6 +1154,7 @@
 #else 
  #define NOZZLE_TO_PROBE_OFFSET { -31.75, -14.69, 0}  //prime 2023.02.10 朱工提供
 #endif
+
 // Most probes should stay away from the edges of the bed, but
 // with NOZZLE_AS_PROBE this can be negative for a wider probing area.
 #define PROBING_MARGIN 3 
@@ -1414,7 +1416,7 @@
 
   #define FIL_RUNOUT_STATE     HIGH       // Pin state indicating that filament is NOT present.
   #define FIL_RUNOUT_PULLUP               // Use internal pullup for filament runout pins.
-  //#define FIL_RUNOUT_PULLDOWN           // Use internal pulldown for filament runout pins.
+  //#define FIL_RUNOUT_PULLDOWN           // (V3SE default) Use internal pulldown for filament runout pins.
   //#define WATCH_ALL_RUNOUT_SENSORS      // Execute runout script on any triggering sensor, not only for the active extruder.
                                           // This is automatically enabled for MIXING_EXTRUDERs.
 
@@ -1455,7 +1457,7 @@
   // With multiple runout sensors use the %c placeholder for the current tool in commands (e.g., "M600 T%c")
   // NOTE: After 'M412 H1' the host handles filament runout and this script does not apply.
   #define FILAMENT_RUNOUT_SCRIPT "M600"
-
+  //#define FILAMENT_RUNOUT_SCRIPT "M412 H"
   // After a runout is detected, continue printing this length of filament
   // before executing the runout script. Useful for a sensor at the end of
   // a feed tube. Requires 4 bytes SRAM per sensor, plus 4 bytes overhead.